To Replace the IT4700 Interface Cable:
1. Turn the power to the host system OFF.
2. Disconnect the Imager's cable from the terminal or computer.
3. Insert a small, flat head screwdriver into the slot between the cable and the
back end of the housing.
4. Press the screwdriver tip down to
depress the retention tab, releas-
ing the connector.
5. Pull the connector out of the
Imager while maintaining pres-
sure on the screwdriver.
6. Replace with the new cable.
Insert the connector into the opening at the base of the Imager. Press firmly.
The connector is "keyed" to go in only one way, and will click into place.
Cable
Release
10 - 3