Specification Table - JAI AT-030MCL User Manual

13.2. Specification table

Specifications
Optical system
Scanning system
Frame rate full frame
Pixel clock
Line frequency
CCD sensors
Sensing area
Cell size
Active pixels
Pixels in video output
2/3 partial
1/2 partial
1/4 partial
1/8 partial
Variable partial
Sensitivity (on sensor)
(minimum)
S/N ratio
Digital Video outputs.
Iris video output
Inputs TTL
Camera Link
Outputs TTL
Camera Link
White balance
Tracking range
Gain
Gain range
Gamma
Knee correction
Shading Compensation
Linear Matrix
Blemish compensation
Noise reduction
Synchronization
Trigger modes
Trigger function
Shutter speed (Preset)
Programmable exposure
Auto shutter
Pulse Width Control
LVAL accumulation
Smear less mode
Control interface
Operating temperature
Humidity
Storage temp./humidity
Vibration
AT-030MCL
V binning
full
Programmable start line and height, start line 1 to 493, height 2 to 494
V binning 659 (h) x 247 (v) 193.88 fps. (257 lines per frame) (Maximum)
3 x 8-bit RGB via single port Camera Link base configuration or
3 x 10-bit RGB via dual port Camera Link medium configuration or
3 x 12-bit RGB via dual port Camera Link medium configuration
Manual/one push, continuous, preset(4000K, 4600K,5600K)
White balance setting in factory:7800K (R and B gain settings=0)
Master -3 to +21 dB. R and B –7 to +10 dB (0.036dB/Step)
Continuous, Edge Pre-select, Pulse Width Control, Fast PWC,Reset continuous
OFF,1/250, 1/500, 1/1000, 1/2000, 1/4000, 1/8000, 1/18000, 1/2500, 1/40000,
and 1/130,000 sec. R, G and B can be set individually
AT-030MCL
1/3 inch F4.0 prism
Progressive
120.49 frames/second (511 lines per frame)
58 MHz
61.571 kHz (942 clk per line)
49.828 kHz (1164 clk per line)
3 x 1/3" IT CCD on prism. Sony ICX424AL
4.88 (h) x 3.66 (v) mm 1/3 inch diagonal
7.4 (h) x 7.4 (v) m
659 (h) x 494 (v)
659 (h) x 494 (v) 120.49 fps. (511 lines per frame)
659 (h) x328 (v) 169.62 fps (363 lines per frame)
659 (h) x 246 (v) 208.72 fps. (295 lines per frame)
659 (h) x 122 (v) 322.36 fps. (191 lines per frame)
659 (h) x 60 (v) 422.96 fps. (139 lines per frame)
0.34 Lux, max gain, 50% video
>50 dB. (On Green)
0.7 V p-p, 75  NUM luminance signal w/o Sync
Ext. trigger 4 Vp-p 2 V. (TTL or 75 )
Ext. trigger (LVDS)
XEEN output 4 V p-p from 75  source (TTL)
RGB 8/10/12-bit video output. D0 – D9
Pixel clock, DVAL, LVAL, FVAL and EEN (LVDS)
-6 to +6 dB. (4000K to 9000K)
Manual for all 3 colors
1.0 (OFF) , 0.6, 0.45 or LUT (Look Up Table)
Knee point and knee slope for R, G and B channel
ON/OFF
Linear/Preset (sRGB, Adobe RGB)/User
ON(use factory preset data)/OFF
ON / OFF
Int. X-tal
LVAL synchronous or LVAL asynchronous auto detect
0L to 511L
Yes
2L to 122640 L
SYNC/ASYNC auto detect
Available for EPS and PWC
EIA-644 LVDS
-5C to +45C
20 - 80% non-condensing
-25C to 60C/20% - 80 % non-condensing
3 G (15 Hz – 200 Hz in XYZ)
- 51 -