Specification Table - JAI AT-200CL User Manual

13.2. Specification table

Specifications
Optical system
Scanning system
Frame rate full frame
Pixel clock
Line frequency
CCD sensors
Sensing area
Cell size
Active pixels
Pixels in video output
2/3 partial
1/2 partial
1/4 partial
1/8 partial
Variable partial
Sensitivity (on sensor)
(minimum)
S/N ratio
Digital Video outputs.
Iris video output
Inputs TTL
Camera Link
Outputs TTL
Camera Link
White balance
Tracking range
Gain
Gain range
Gamma
Knee correction
Shading Compensation
Linear Matrix
Noise reduction
Synchronization
Trigger modes
Trigger function
Shutter speed (Preset)
Programmable exposure
Auto shutter
Pulse Width Control
LVAL accumulation
Smear less mode
Control interface
Functions controlled by
Camera Link
Operating temperature
Humidity
Storage temp./humidity
AT-200CL
V binning
full
Programmable start line and height, start line 1 to 1236, height 1 to 1236
V binning
3 x 8-bit RGB via single port Camera Link base configuration or
3 x 10-bit RGB via dual port Camera Link medium configuration or
3 x 12-bit RGB via dual port Camera Link medium configuration
Manual/one push, continuous, preset (4000K, 4600K,5600K)
White balance setting in factory:7800K (R and B gain settings=0)
Continuous, Edge Pre-select, Pulse Width Control, Reset continuous
OFF,1/60, 1/100, 1/120, 1/250, 1/500, 1/1000, 1/2000, 1/4000, 1/7000, 1/17,000
Trigger, shutter, scanning, readout, polarity, gain, set-up, white balance, gamma,
knee point and slope, linear matrix, blemish, shading compensation
AT-200CL
1/1.8 inch F4.0 prism
Progressive
20.31 frames/second (1236 lines per frame)
50 MHz
25.432 kHz (1966 clk per line)
22.563 kHz (2216 clk per line)
3 x 1/1.8" IT CCD on prism. Sony ICX274AL
7.16 (h) x 5.43 (v) mm
4.4 (h) x 4.4 (v) m
1628 (h) x 1236 (v)
1628 (h) x 1236 (v) 20.31 fps. (1252lines per frame)
1628 (h) x825 (v) 28.42 fps (895 lines per frame)
1628 (h) x 621 (v) 35.27 fps. (721 lines per frame)
1628 (h) x 311 (v) 55.896 fps. (455 lines per frame)
1628 (h) x 155 (v) 79.23 fps. (321 lines per frame)
1628 (h) x 618 (v) 35.93 fps. (628 lines per frame)
1.0 Lux, max gain, 50% video
>50 dB. (On Green)
0.7 V p-p, 75  NUM luminance signal w/o Sync
Ext. trigger 4 Vpp 2 V. (TTL or 75 )
Ext. trigger (LVDS)
XEEN output 4 Vpp from 75  source (TTL)
RGB 8/10/12-bit video output. D0 – D9
Pixel clock, DVAL, LVAL, FVAL and EEN (LVDS)
-6 to +6 dB. (4000K to 9000K)
Manual for all 3 colors
Master -3 to +12 dB. R and B –6 to +6 dB
1.0 (OFF) , 0.6, 0.45 or LUT (Look Up Table)
Knee point and knee slope for R,G and B channel
ON/OFF
Manual for R, G and B / Preset (sRGB, Adobe RGB)
ON/OFF
Int. X-tal
LVAL synchronous or LVAL asynchronous auto detect
and 1/51,000 sec. R, G and B can be set individually
0L – 1252L. RGB common or individual. (L=39.32 s.)
1/20 to 1/2400 sec
2L to 50080 L
SYNC/ASYNC auto detect
Available for EPS and PWC
serTC and serTFG via Camera Link
-5C to +45C.
20 - 80% non-condensing
-25C to 60C./20% - 80 % non-condensing
- 45 -