Eps Timing (Programmable Exposure Individual) - JAI AT-030MCL User Manual

9.2.2

EPS Timing (Programmable Exposure Individual)

If the shutter mode is set at SM=2 (Programmable Exposure(Individual)),
In the EPS trigger mode, if the programmable exposure is set at Individual, each
exposure for R, G and B channels is executed when the trigger is input.
Each exposure is activated as it is set. The signal output for the channel with the
smaller exposure time is held until the longest exposure is completed and then, all
channels are read out.
Minimum trigger interval
Smear
less
Mode
Off LVAL
Async
LVAL
Sync
On LVAL
Async
Note 1: In partial scan or V-binning mode, EPS programmable exposure value must be within total lines of
1 frame in continuous mode on each scan format.
Note 2: In partial scan or V-Binning mode, EPS programmable exposure value can be set at maximum
511L.
Note: If the trigger of Active High is input through 10pin, dummy pulses must be applied
more than one time when the camera is activated.
AT-030MCL
Minimum trigger interval (Line）
511L + [Maximum Programmable Exposure value among R,G and B channels]
+ 4L
511L + [Maximum Programmable Exposure value among R,G and B channels]
– [Minimum Programmable Exposure value among R,G and B channels]+ 5 L
◆ The range of Programmable Exposure: 7L to 511L (Note 1)
(Smear less[87L] ) +[Maximum value of Programmable Exposure among R,G
and B channels] ] + 511L + 3L (Note:2)
Vertical Binning =Off、1L=16.24us
Vertical Binning =On 、1L=20.07us
- 27 -