Table of Contents
Advertisement
Privacy
Blocks
After the block is created, it can be repositioned by dragging it with a mouse.
To remove a block, double click on it.
9. Right click anywhere on the desktop to return to the VIDEO SETUP menu.
10. Click the confirm icon (
11. Repeat this procedure for the other camera channels, if necessary.
3.5 Network configuration settings
Use the NETWORK menu to configure your DVR for use on a LAN, for access through the Internet, for access from a smartphone, and
for issuing automated email when alarm conditions occur.
Refer to the Chapter 4, Networking your DVR for configuring your system for local LAN and Internet access. For other network
settings, including DDNS, EMAIL, MOBILE, and OTHER SETTINGS, refer to the chapter DVR System Menus.
The default IP addresses and port settings of your DVR may be different from those shown in this document. Always use
NOTE
network settings that are compatible with your network(s).
3.6 Alarm configuration settings
Use the ALARM menu to configure your DVR for behavior when the hard disk drive becomes full, and for motion detection
sensitivity of each channel.
1. Click the Settings icon on the Tool Bar. The SYSTEM tab window will open.
2. Click the ALARM tab to open the ALARM settings menu.
a
) in the lower right corner of the screen, then click the Confirm button in the Note window.
4-Camera H.264 Security System Setup Guide
SECTION 3: SYSTEM SETUP
25
Advertisement
Table of Contents
