Table of Contents
Advertisement
7.3.7 Record Mode
Record mode includes two general categories: ALWAYS and SCHEDULE.
ALWAYS: indicates that the DVR will record the channel selected continuously.
SCHEDULE: This setup allows you to create a weekly schedule for recording. This assures that only selected events are
recorded on the HDD. For example, you may set up the system to record continuously during business hours, record at lunch
time only when an alarm is triggered, and record at night when motion is detected and/or an alarm is triggered.
NOTE: Manual recording continues until stopped by the operator. It overrides all settings.
CHANNEL: You can select all channels or just one channel. There are three modes for recording: ALARM, NORMAL and NO RECORD.
Different colors indicate different recording modes: Red indicates alarm record, green indicates normal record, gray indicates no
recording.
To set up weekly schedules, click on the box of the recording mode you want (Alarm, Normal or No record), then click each box
in the schedule time line that you want to apply the mode to. You can also left click and drag a frame over boxes in the schedule
time line that you want to apply the mode to. You can use the [FROM-TO] pull-down menus and COPY button settings to repeat
setting from one day to another day, or to all days.
After you setup the schedule, activate it by clicking the "check" button in the lower right corner of the window.
When you select the ALARM option, it is necessary to set the motion detection sensitivity and area. Please refer to Motion
NOTE
Detect on page 72,for details. Configure the alarm triggering settings before selecting alarm recording.
To restore to default settings, scroll to the "back" button in the lower right corner of the window, then press ENTER.
To save the new settings, scroll to the "check" button in the lower right corner of the window, then press ENTER.
4-Camera H.264 Security System Setup Guide
SECTION 7: DVR SYSTEM MENUS
63
Advertisement
Table of Contents
