Dual Pulley Plate 2 - Life Fitness Fit-1 Assembly Instructions Manual

3/8 X 3/4" 56
8
50
TIGHTEN!
FIGURE 27
STEP 27:
• Route the LAT CABLE (44) through the REAR UPRIGHT (5). Then assemble two 4-1/2" PULLEYS (38) and asssemble the
PULLEYS to the REAR UPRIGHT (5) using four RH CAPS (78), one 3/8 X 2-1/2" BOLT (64), one 3/8 X 3" BOLT (65), four
3/8" SAE WASHERS (75), four 3/8" RH WASHERS (76), three 3/8 X 1/2" FLANGE SPACERS (54), one 3/8 X 3/4" FLANGE
SPACER (56) and two 3/8" LOW HEIGHT LOCK NUTS (73) as shown in FIGURE 27. (NOTE: Make sure CABLE is in
groove of PULLEY before tightening BOLTS.)
• SECURELY tighten STACK BOOM (8) to the REAR UPRIGHT (5) as shown in FIGURE 27.
• Slide the two 13/16" SHAFT COLLARS (50) to the top of the STACK BOOM (8) and SECURELY tighten the SHAFT COLLAR
(50) set screws.
FIGURE 28
STEP 28:
• Route the LAT CABLE (44) around one 4-1/2" PULLEY (38) and up thru the STACK BOOM (8).Assemble the PULLEY to two
DUAL PULLEY PLATES (21) using two RH CAPS (78), one 3/8 X 1-3/4" BOLT (62), two 3/8" SAE WASHERS (75), two 3/8"
RH WASHERS (76) and one 3/8" LOW HEIGHT LOCK NUT (73) as shown in FIGURE 28.
73
75
76
8
44
5
65 3/8 X 3" (73m)
38
21
19
78
73
75
76
54
44
38
64 3/8 X 2-1/2" (67m)
62 3/8 X 1-3/4" (43m)
78