Life Fitness Fit-1 Assembly Instructions Manual page 15

STEP 18:
• Slide two 5" ACCORIDIAN SLEEVES
(36) over the shafts on the PIVOT ARM
(9) as shown in FIGURE 18.
• Slide two PILLOW BLOCKS (37) over
the shafts on the PIVOT ARM (9) as
shown in FIGURE 18.
3/8 X 3" (76m) 72
BUTTON HEAD
74
35
FIGURE 19
STEP 19:
• SECURELY assemble the PILLOW BLOCKS (37) on the PIVOT ARM (9) to the LEFT and RIGHT BOOM SUPPORTS (3 & 4)
using four 3/8 X 3" BUTTON HEAD BOLTS (72), four BLACK 3/8" SAE WASHERS (74), four RH WASHERS (76), four 3/8"
SAE WASHERS (75), four 3/8" LOW HEIGHT LOCK NUTS (73) and four RH CAPS (78) as shown in FIGURE 19.
• IMPORTANT! When PIVOT ARM (9) is centered and level in the PILLOW BLOCKS (37), tighten the PILLOW BLOCK set
screws.
• Slide two 1-3/8" OD COVER CAPS (35) over the ends of the shaft on the PIVOT ARM (9) as shown in FIGURE 19.
1/2
0
10
FIGURE18
37
75
73
76
3
1 2
1/2
20 30 40 50
4
78
3
1/2 1/2
60 70 80 90
15
36
9
4 5
1/2
100 110 120 130
37
9
6
1/2
140 150