TANDBERG 150 MXP User Manual page 12

Unpacking, Assembling, and Connecting Your 150MXP
!
How to configure the
unit is described in
Adminstrator Settings.
Assembling the unit is really easy. The system lies fully assembled
in the box. Remove the accessories box and carefully lift the system
out of the box. To protect the camera lens while installing, we recom-
mend that you let the camera lens cap remain on. In the accessories
box you find:
• LAN cable
• Power adaptor and power cable
Handset is an optional device
that must be ordered separately.
Contact your TANDBERG
representative for more
information.
Mounting the (optional) handset.
Slide the handset bracket into
the system's bottom plate tracks.
Place the system in an upright
position and lay the handset in its
place. The handset is held in place
by magnets.
D 13640.04
MARCH 2006
Socket for
optional
handset's
cable
If you have a single LAN
TIP!
connection only and this is in
use by your PC already, con-
Power
nect your PC to the 150MXP
and the 150MXP to the LAN
to let both units have internet
access.
12
Socket for optional headset
The TANDBERG 150MXP has a 2.5mm 3-pole mini-jack connector at its
right side marked with a headset symbol. This allows the user to connect
a standard telecommunications headset to the system. Headsets with
the microphone positioned in front of the user's mouth, connected to the
earphone through a rod, tend to give more echo than earbud headsets
with the microphone attached to the cord. TANDBERG recommends the
Plantronics MX100 headset (http://www.plantronics.com, products >
mobile). Note that the maximum outer diameter of the plug must be
7.0 mm or smaller. A plug with a bigger outer diameter will not fit the unit.
Alternatively an extension cord may be used.
PC
Connect your
LAN here
TANDBERG 150MXP
USER GUIDE