1.11
How to Enter Heading
Choose manual or automatic heading input as
follows:
1. Right-click anywhere in the [Own ship in-
formation] box to show the context-sensi-
tive menu.
2. Click [Setting].
3. Click [System Sensor Settings] or [Local
System Settings] as applicable.
4. Click the [HDG] tab.
Fill circle for automatic
heading input
Fill circle for manual
heading input
Fill circle for automatic
heading input
Fill circle for manual
heading input
5. For automatic input follow the procedure below. For manual input go to step 6.
1) Check [Sensors].
2) Set the priority for each sensor connected, referring to section 1.10.
3) Go to step 7.
6. For manual input, check [Manual]. Enter heading by spinning the scrollwheel or
entering numeric data with the keyboard on the Control Unit.
7. Click the [Save] button to save settings then click the [Close] button to close the
menu.
Sensor
list
Sensor
list
Local sensor settings
System sensor settings
1. INTRODUCTION
1-11