Accessing Computer Setup (F10) Utility - HP Z1 Maintenance And Service Manual

Hide or show the integrated I/O functionality, including serial, USB, or parallel ports, audio, or
●
embedded NIC. Hidden devices are inaccessible, which increases system security.
Enable or disable removable media boot ability.
●
Enable or disable removable media write ability (if supported by hardware).
●
Replicate the workstation setup by saving system configuration information on CD and restoring
●
it on workstations.
Execute self-tests on specified SATA hard disk drives (if supported by the drive).
●

Accessing Computer Setup (F10) Utility

To access Computer Setup (F10) Utility:
1. Power on or restart the workstation.
2. When the display is active and Press the Esc key for Startup Menu appears at the bottom of the
screen, press
If you do not press
on, and press
starting if you miss the opportunity to press F10.
3. Select the language from the list and press the
In the Computer Setup (F10) Utility menu, five headings are displayed: File, Storage, Security,
Power, and Advanced.
NOTE:
4. Use the left and right arrow keys to select the appropriate heading, use the up and down arrow
keys to select an option, and then press Enter.
5. Choose from the following:
To apply and save changes, select File > Save Changes and Exit, and then press
●
accept the changes.
To remove changes you have made, select Ignore Changes and Exit, and then press
●
to acknowledge the cancellation.
To reset to factory settings, select File > Default Setup > Restore Factory Settings as
●
Default. Press
restores the original factory system defaults.
CAUTION:
because the Complementary Metal-Oxide Semiconductor (CMOS) nonvolatile storage could become
corrupted. Power off after you exit the F10 Setup screen.
14 Chapter 2 System management
F10 or Esc.
F10 or Esc at the appropriate time, try again. Turn the workstation off, then
F10 again to access the utility. You can also press
The option for selecting the language is available on first boot only.
Enter to accept the changes, and then select Apply Defaults and Exit. This
Do not power off the workstation while saving Computer Setup (F10) Utility changes,
Ctrl +
Enter key.
Alt + Delete before
Enter to
Enter