Accessing Computer Setup (F10) Utility - HP Z440 Workstation Series Maintenance And Service Manual

●
Enable power-on password prompts during system restarts (warm-starts) and when the computer is
started.
●
Hide or show the integrated I/O functionality, including serial, USB, or parallel ports, audio, or
embedded NIC. Hidden devices are inaccessible, which increases system security.
●
Enable or disable removable media boot ability.
●
Enable or disable removable media write ability (if supported by hardware).
●
Replicate the workstation setup by saving system configuration information to removable storage or
restoring it.

Accessing Computer Setup (F10) Utility

Accessing Computer Setup (F10) Utility requires a keyboard. To access Computer Setup (F10) Utility:
1. Turn on or restart the workstation.
2. When the display is active and Press the Esc key for Startup Menu appears at the bottom of the screen,
press
If you do not press
press
press
3. Select a language from the list, and press the
In the Computer Setup (F10) Utility menu, the following headings are displayed: Main, Security,
Advanced, and UEFI Drivers.
NOTE:
press
languages.
4. Use the left and right arrow keys to select the appropriate heading, use the up and down arrow keys to
select an option, and then press Enter.
5. Choose from the following:
●
To apply and save changes, select Main and then select Save Changes and Exit. Press
accept the changes.
●
To remove changes you have made, select Ignore Changes and Exit, and then press
acknowledge the cancellation.
●
To restore factory settings, select Main, and then select Apply Defaults and Exit.
CAUTION:
Complementary Metal-Oxide Semiconductor (CMOS) nonvolatile storage could become corrupted. Turn off
after you exit the F10 Setup screen.
26 Chapter 2 System management
F10 or Esc.
F10 or Esc at the appropriate time, try again. Turn the workstation off, then on, and
F10 again to access the utility. You can also press
F10 before the message disappears.
The option for selecting the language is available on first boot only. To reset the selection,
Esc during POST and from the Startup menu, select Change Language to switch between
Do not turn off the workstation while saving Computer Setup (F10) Utility changes, because the
Ctrl + Alt + Delete
Enter key.
before starting if you do not
Enter to
Enter to