Configuring The System Bios To Enable Embedded Sata Raid Functionality - HP Z1 Maintenance And Service Manual

Configuring the system BIOS to enable embedded SATA RAID functionality

To set up a RAID configuration, the SATA emulation mode must be set to AHCI+RAID in the BIOS
setup menu. This is the default setting. If the mode has been changed, follow these steps to change it
back.
1. During startup, press
and select options.
2. Select a language from the list, and then press Enter.
3. Select Storage > Storage Options, and then press Enter.
4. Select SATA Emulation > RAID+AHCI, and then press
NOTE:
mode. This BIOS is used only to support serial-attached drives that are configured as a RAID
array.
5. Select Advanced > Power-On Options, and then press Enter.
6. Select POST Messages > Enable, and then press
7. Select Advanced > Device Options, and then press Enter.
8. Select SATA RAID Option ROM Download, and then press Enter.
9. Select Enable, and then press
10. Select File > Save Changes and Exit, and then press Enter.
11. Press
98 Appendix B Configuring RAID devices
F10 to enter Computer Setup (F10) Utility. Use the arrow keys to navigate
The SATA AHCI BIOS executes when you select RAID+AHCI for the SATA emulation
Enter to accept the changes when prompted.
F10
F10 to save the settings.
F10 to save the settings.
to save the settings.