Accessing The Computer Setup (F10) Utility - HP Z220 SFF Maintenance And Service Manual

Specify the Asset Tag or property identification number assigned by the company to this
●
workstation.
Enable power-on password prompts during system restarts (warm-starts) and power on.
●
Hide or show the integrated I/O functionality, including serial, USB, or parallel ports, audio, or
●
embedded NIC. Hidden devices are inaccessible, which increases system security.
Enable or disable removable media boot ability.
●
Enable or disable removable media write ability (if supported by hardware).
●
Replicate the workstation setup by saving system configuration information on CD and restoring it
●
on workstations.
Execute self-tests on specified SATA hard disk drives (if supported by the drive).
●

Accessing the Computer Setup (F10) Utility

To access the Computer Setup (F10) Utility:
1.
Power on or restart the workstation.
2. When the display is active and Press the ESC key for Startup Menu appears at the bottom
of the screen, press
If you do not press
and press
you miss the opportunity to press F10.
3. Select the language from the list and press the
In the Computer Setup (F10) Utility menu, five headings are displayed: File, Storage, Security,
Power, and Advanced.
NOTE:
4. Use the left and right arrow keys to select the appropriate heading, use the up and down arrow
keys to select an option, and then press Enter.
5. Choose from the following:
To apply and save changes, select File > Save Changes and Exit, then press
●
accept the changes.
To remove changes you have made, select Ignore Changes and Exit, then press
●
acknowledge the cancellation.
To reset to factory settings, select File > Default Setup > Restore Factory Settings as
●
Default. Press
This restores the original factory system defaults.
CAUTION:
Utility changes, because the Complementary Metal-Oxide Semiconductor (CMOS) nonvolatile storage
could become corrupted. After you exit the F10 Setup screen, you can disconnect power from the
workstation.
F10 or Esc.
F10 or Esc at the appropriate time, try again. Turn the workstation off, then on,
F10 again to access the utility. You can also press
The option for selecting the language is available on first boot only.
to accept the changes, and then select Apply Defaults and Exit.
Enter
Do not power off the workstation while the ROM is saving the Computer Setup (F10)
Ctrl + Alt
Enter key.
The Computer Setup (F10) Utility
+ Delete before starting if
Enter to
Enter to
43