HP Z1 Maintenance And Service Manual page 30

Table 2-1 Computer Setup (F10) Utility menu descriptions (continued)
Heading
20 Chapter 2 System management
Option Description
POST Delay (in seconds) (5, 10, 15, 20, None)—Adds a specified delay to the POST
●
process. This delay is sometimes needed for hard disk drives on some expansion cards
that spin up slowly (so slowly that they are not ready to start by the time POST is finished).
The POST delay also gives you time to select F10 to enter Computer Setup (F10) Utility.
Remote Wakeup Boot Source—Enables you to set the remote wakeup boot source as:
●
Local Hard Drive
◦
Remote Server
◦
Factory Recovery Boot Support—(Disabled/Enabled)
●
Bypass F1 Prompt on Configuration Changes
●
POST Memory Manager Runtime Allocation (Disabled/Enabled)—Forces legacy POST
●
Memory Manager (PMM) to use runtime memory for allocation. This prevents Hibernation
(S4) issues with some EFI Windows installations.
BIOS Power-On Enables you to disable or specify a weekday and time for BIOS power-on.
Bus Options Configures graphics cards per workstation slots. In multi-graphics card configurations, this
option designates one card as primary graphics, and the other card as secondary graphics.
PCI SERR# Generation (Enabled/Disabled)—Controls PCI SERR# generation for ill-
●
behaved PCI add-in cards (that can generate SERR# spuriously)
Device Options Enables you to set the following device options:
Turbo Mode (Enabled/Disabled)—Allows Intel Processors to run at frequencies greater
●
than maximum. The CPU must support this capability for it to show up in Device Options.
S5 Wake on LAN (Enabled/Disabled)—Allows unit to be powered on over the network.
●
Num Lock State at Power-On (On or Off)
●
IGD (Integrated Graphic Device) Memory—Displayed when Integrated Video is Enabled.
●
Sets the maximum amount of system memory that can be allowed as graphics memory
(32, 128 (default), 256, 512 MB).
Internal speaker—(Enable or Disable)
●
NIC PXE Option ROM
●
SATA RAID Option ROM
●
Multi-processor (Activates a single core.)—(Enable or Disable)
●
Hyper-Threading—(Enable or Disable)
●
Slot Settings Enables you to set the following options for the Mini PCIe slots:
Slot 1 Option ROM Enabled/Disabled
●
Slot 2 Option ROM Enabled/Disabled
●
Slot 3 Option ROM Enabled/Disabled
●
AMT Lets you set the following AMT (Intel Active Management Technology) configuration options:
Configuration
AMT (Enabled/Disabled)—Allows for remote discovery, repair and protection of networked
●
workstations. Enabling the AMT function also enables the Network Controller (required for
AMT to function correctly).
Unconfigure AMT/ME (Disabled/Enabled) 2—Restores AMT/ME defaults. When you save
●
and exit after enabling this option, you will be prompted to complete the process upon
restart. A Setup Password (even if one is set) does not need to be entered to complete the
process.
Download (Enable or Disable)
1
Download (Enable or Disable)
1