Connecting To A Node Or Room On The Internet - Yaesu FT1DR Instruction Manual

(3)
Connected to the local node, successfully connected
to Internet nodes or rooms (nodes or rooms are the
same as ones previously used)
(4)
Connected to the local node, successfully connected
to Internet nodes or rooms (nodes or rooms are
different from ones previously used)
is displayed, rotate the O. Call signs
When the
of nodes or rooms where you previously established
connection will flash.
While the [ X ] is flashing, press the % to re-establish
Tip
connection to the local node.
Tip When any local node cannot be found, [ X ] will disappear
in 5 minutes.
Tip When the detected local node is a repeater station, [[ R ]]
will appear below [ X ].
Caution
WIRES-X can be used only on band A.
When using band B (shown on the bottom part of the screen) as the operation band, after
pressing and holding % for 1 second or more, band A (shown on the top part of the screen) will
automatically become the operation band.

Connecting to a node or room on the Internet

You can connect to a desired node or room in one of the following ways.
• Selecting an accessible node or room from the list
• Specifying the node name or room name
• Selecting the most recently connected node or room
• Specifying the DTMF ID of the desired node or room
● Searching from the node & room lists
1
When the connection destination is displayed, press and
hold H for 1 second or more.
The menu list of the local node will appear.
Connecting to a Faraway Station Using WIRES-X
9