Connecting The Wires-X Feature; What Is Wires-X; Connecting To A Wires-X Digital Node (Recommended); Connecting To The Other Node Id Or The Other Room Id - Yaesu FTM-3207DE Operating Manual

Connecting the WIRES-X feature

What is WIRES-X?

WIRES-X is an Internet communication system which expands the range of amateur
radio communication. You may employ Internet communications by connecting from your
transceiver to a WIRES-X local node station.
* FTM-3207DR/DE does not accommodate the transmission/reception of messages,
images, audio messages, or location information.

Connecting to a WIRES-X digital node (Recommended)

* Ascertain the DSQ code or the DG-ID setting of the WIRES-X node station. Connecting
to the WIRES-X node requires the transceiver DG-ID be set according to the DSQ code
or the DG-ID code set on the WIRES-X node station.
* Confirm that the operating mode of WIRES-X node has been set to the C4FM digital
mode.
1. Set the transmit/receive DG-ID to the same ID number as the node station.
For more details on the DG-ID number, see page 22
2. Transmit on the corresponding transmit/receive frequency.
• If the signal is received from the node, continue to transmit using the DGID setting
as is.
• If the signal is not received from the node. à proceed to "Connecting to the other
node ID or the other room ID"

Connecting to the other node ID or the other room ID

1. Press and hold the [MHz(SETUP)] key to enter the Setup Menu.
2. Rotate the DIAL knob to select "W-DGID 49", then press the [MHz(SETUP)] key.
3. Rotate the DIAL knob to set the WIRES-X DG-ID to the same ID number as the node
station.
Display
DGID01-99
AUTO
(default setting)
4. Press the PTT switch, or press and hold the [MHz(SETUP)] key to save the new setting
and return to normal operation.
5. Press the [P3] key.
"WIRES" blinks.
36
Only nodes matching the set DG-ID number may be connected.
Only open nodes, set to the DG-ID number "00" may be connected.
Description
FTM-3207DR/DE Operating Manual