Voce PR14037000 Operator's Manual page 11

Important: Do not fill the tube directly above the cup dispense position. Allow the
cup turret motor to rotate a full tube to the cup dispense position when the machine
is powered up. Rotating the cup turret by hand will damage the mechanism.
Note: If you are loading paper cups, first inspect each pack for damage to the cup
rims. Damaged cups must not be used.
4. Turn the machine on with the main switch on the back panel. The cup turret
mechanism will index the first available cups to the dispense position and drop the
cup stack into the cup drop mechanism. Fill the remaining empty cup stack with cups
and replace the lid.
5. All Models: The water inlet valve will open and
the heater tank will start to fill. As the water
heats, ensure that no water overflows from the
heater tank overflow pipe into the waste bucket.
When the machine has powered up, the LCD will
display the message as shown opposite. Check
the system for leaks.
Note! The machine has a safety cut-out which
will only allow the heater tank to fill for a
maximum of two minutes. If after power-up the
heater tank has not filled within this time, the
mains power supply should be switched off and
then on again to reset the heater tank time-out.
After the above message the "Sorry Out Of Service Water Tank Heating" message is
displayed.
6. B2C Models: While the machine is powering up, the LCD will display the Initialising
message. As the machine initialises a small amount of water is pumped through the
system and is discharged into the waste bucket.
7. Before using the B2C machine for the first time it is necessary to purge the water
system to ensure any water left in the system during transport is purged. When the
machine enters standby press button 9 on the Service Keypad fitted inside the door.
The machine will pump approximately 400ml of water through the system
discharging it into the waste bucket.
Important: Should the machine fail to fill correctly or leak, turn off the stopcock and
the power to the machine before investigating the fault.
8. Check the LCD display on the front of the machine to ensure that the water has
heated to the correct temperature and that the machine is in standby mode.
7