Table Of Contents - Baxi Fires Division 740FS Installer's Manual

Section Heading
1. SAFETY
2. APPLIANCE DATA
3. GENERAL INSTALLATION REQUIREMENTS
4. PACK CONTENTS
5. FIREPLACE CHECK
6. IGNITION CHECK
7. GAS SUPPLY CONNECTION
8. PREPARING APPLIANCE FOR INSTALLATION
9. CONVECTION BOX INSTALLATION
10. BURNER AND SUPPLY PIPE INSTALLATION
11. CERAMIC WALLS INSTALLATION
12. FASCIA AND CONTROL LINKAGE
13. FITTING THE CERAMIC FUEL EFFECT
14. FRONT / CASTINGS INSTALLATION
15. FULL OPERATING CHECKS
15.1 Checking the control settings.
15.2 Check for spillage.
15.3 Flame supervision and spillage monitoring system.
16. FINAL REVIEW
17. SERVICING & PARTS REPLACEMENT
17.1 Checking the aeration setting of the burner.
17.2 To remove the ignition microswitch.
17.3 To remove the gas shut-off microswitch.
17.4 To remove the fascia.
17.5 To replace the control slide unit.
17.6 To replace the control slide button.
17.7 To remove the complete burner unit.
17.8 To remove the electronic ignition generator.
17.9 To remove the thermocouple interrupter block.
17.10 To remove the pilot unit.
17.11 To remove the shut-off tap.
17.12 To remove the gas flow rate controller.
17.13 To replace the burner.
17.14 To remove the main burner injector.
17.15 To remove the appliance from the fireplace.
©
Baxi Heating U.K. Limited 2007.
INSTALLER GUIDE
CONTENTS
Page 4
Page
5
6
7
16
20
21
22
22
25
28
30
31
34
34
36
36
36
37
38
39
40
40
40
41
42
43
43
44
44
45
45
46
46
47
47