Baxi Fires Division 740FS Installer's Manual page 23

unless the supply pipe is to pass through it.
5. The appliance is supplied with two fireback spacers. Do
not fit the fireback spacers if the fire is to be installed
into a precast or clay flue block system as in section
3.2.2.These should extend backwards to ensure sufficient
clearance from the back of the fireplace. Remove the label
and retaining screws from the rear sides of the convection
box. Position the fireback spacer as shown in figure 12.
Secure the fireback spacers using the screws removed
previously and the two supplied with the fire.
6. The 'Adorn', 'Visage', 'Eternal', 'Decadent',
"Obsession" and 'Dream' models have an outlet baffle
supplied with the appliance fascia. Fit this to the convected
air outlet of the appliance using the three self tapping
screws supplied with the fascia (See figure 13).
The 'Icon' model has a heat baffle supplied with the
appliance fascia. Fit this to the convected
air outlet of the appliance using the three
self tapping screws supplied with the
fascia (See figure 13).
7. The 'Icon' fascia is supplied with two
port covers. To fit the port covers
unscrew the four cross over port screws
shown in figure 14. Put the port covers in
place and refit the screws previously
removed. Ensure that the screws are tight
and that the cross over ports have
returned to
their original
position. Also
check that
there are no
gaps between
the cross over
ports and the
surfaces they
are screwed to
(See figure 14).
©
Baxi Heating U.K. Limited 2007.
INSTALLER GUIDE
Figure 14. Fitting port covers to 'Icon' model.
Figure 13. Fitting outlet baffle (The
outlet baffle design may differ from that
shown)
Page 23
Figure 12. Fireback
spacers.