Fitting The Ceramic Fuel Effect; Front / Castings Installation - Baxi Fires Division 740FS Installer's Manual

13. FITTING THE CERAMIC FUEL EFFECT

The installer and owner guide for the ceramic fuel effect is supplied with the ceramic
fuel effect. It is important that the fitting guide for the ceramic fuel effect be placed
inside or attached to this guide and handed to the customer following completion of the
'Final review' section.

14. FRONT / CASTINGS INSTALLATION

14.1 "Adorn" bottom front cover.
Place the bottom front cover in position below the fascia bridge.
14.2 "Visage", "Obsession" and "Eternal" fire front casting.
14.2.1 Fit the fire front casting to the fascia. Locate the two screw heads at the rear top
corners of the firefront casting through the
keyhole slots at the inner sides of the fascia. If
the screw heads do not project enough or project
too far, the screws can be adjusted. Lower the
casting so that it rests on the hearth (See figure
40).
14.2.2 Place the bottom front cover casting in
position below the fire front casting.
14.3 "Icon" bottom front cover.
Locate the top flanges of the bottom front cover
behind the bottom edge of the fascia. Fix the
sides of the cover to the fascia bottom corner
brackets with the two knurled screws provided
(See figure 41).
©
Baxi Heating U.K. Limited 2007.
INSTALLER GUIDE
Page 34
Figure 39. Control bar and pivot
bracket (Shown with "Adorn")
Figure 40. Firefront casting (Casting
may differ from that shown).