Fascia And Control Linkage - Baxi Fires Division 740FS Installer's Manual

12. FASCIA AND CONTROL LINKAGE

12.1 Remove the tape securing the control linking bar
to the fascia. Slide the control button upwards as far
as it will go. Make sure that the bottom of the linking
bar is higher than the bottom of the fascia.
12.2 Carefully lift the
fascia. Do not lift it by
the control button.
12.2.1 "Adorn"
fascia
Place the fascia against
the fireplace front surface
so that the retaining strip
at the back of the fascia is
above the two upper
retaining brackets at the
top of the convection box.
Lower the fascia making sure that the rear
retaining strip locates fully over the retaining
brackets on the convection box (See figure 30).
If the inlet pipe runs along the front of the
fireplace, the bottom of the fascia will have to
be swung forwards to clear the pipe while
lowering the casting.
Swing the bottom control linking bar towards
the centre of the fire to clear the front casting.
Slide the front casting sideways, if necessary,
to align the bottom fixing holes with those in the
convection box. Fix the bottom of the casting to
the convection box with two screws and washers
(See figure 31).
12.2.2 "Visage", "Decadent", "Obsession"
and "Eternal" fascia
Place the fascia against the fireplace front
surface so that the two retaining plates at the
back of the fascia are directly above the two
upper retaining brackets at the top of the
©
Baxi Heating U.K. Limited 2007.
INSTALLER GUIDE
Figure 31. "Adorn" fascia
bottom fixing.
Page 31
Figure 30. "Adorn" fascia
top location.
Figure 32. Fascia top location
Figure 33. Fascia bottom location