Ceramic Walls Installation - Baxi Fires Division 740FS Installer's Manual

INSTALLER GUIDE

11. CERAMIC WALLS INSTALLATION

1. Fit the ceramic rear wall inside the "L" bracket on the back face of the burner
compartment. Push the ceramic wall
flat against the back face of the burner
compartment (See figure 28).
2. Remove four screws from the
spillage plate sides (See figure 29).
3. Remove the spillage plate by lifting
it forward.
4. Fit the ceramic side walls against the
side faces of the burner compartment.
The bottom edges of the walls should
rest in the ledges at the sides of the
firebox. Slide them in from the front
Figure 28. Ceramic rear wall installation
and ensure that the touch
the rear wall. The friction
between the side walls
and the rear wall should
hold the side walls in
position (See figure 29)
5. Re-fit the spillage
plate. Be careful not to
damage the edges of the
side walls. The spillage
plate will hold the side
walls in place.
Figure 29. Ceramic side walls installation
©
Page 30
Baxi Heating U.K. Limited 2007.