Excess Flow Safety Valve Reset Procedure - Tera Gear GSF2616AC Assembly Instructions Operations Manual

Burner installation and adjustment
WARNING
Adjusting the air‐shutter while the grill is operating. If it is still hot, please wear protective gear and be careful. Failure to follow
this instruction could cause personal injury.
Flare‐Ups
"Flare‐ups" sometimes occur when food drippings fall onto the hot heat distribution plate or burners and ignite. Some flaring is
normal and desirable as it helps impart the unique flavors associated with grilled foods. Controlling the intensity of the flare‐ups
is necessary, however, in order to avoid burned or unevenly cooked foods and to prevent the possibility of accidental fire.
WARNING
Always monitor the grill closely when cooking and turn the flame level down to LOW or OFF if flare‐ups intensify.
Shutting Off Burners
1. Always turn the valve knob(s) clockwise to the ''HIGH'' position, and then press and turn it to ''OFF''. Never force the knob
without pressing it. This could damage the valve.
2. Promptly turn the gas supply to the "OFF" position at the propane cylinder.
3. Close the lid of the grill.
Excess Flow Safety Valve Reset Procedure
●
The new regulators are equipped with a safety device that restricts the gas flow in the event of a gas leak. However,
unsafe practices of grill operation could activate the safety device without having a gas leak.
●
A sudden shut off of the gas flow typically occurs if you open the liquid propane (LP) tank valve rapidly, or if one or more
of the burner control knobs is in an open position when opening the LP tank valve.
●
This procedure is effective with all sizes of LP tank.
●
To ensure the procedure is safely and successfully performed, please carefully follow these instructions:
1. Close the LP tank valve.
2. Turn all burner control knobs to the OFF position.
3. Disconnect the regulator from the LP tank.
4. Open the lid of the grill.
5. Turn burner control knobs to HIGH.
6. Wait at least 1 minute.
7. Turn burner control knobs OFF.
8. Wait for at least 5 minutes.
9. Re‐connect the regulator to the LP tank.
10. Slowly turn the LP tank valve ¼ turn at a time and have the valve all the way open.
11. With the lid open: For grill with ignition button: turn on only ONE front burner control knob to the HIGH position.
- 14 -