Care And Maintenance - Tera Gear GSF2616AC Assembly Instructions Operations Manual

Ignite the grill by pushing the ignition button. For grill with an automatic ignition: Push down the control knob you
want to light, turn counterclockwise until you hear the ignition click.
12. After the first front burner is lit, turn on the other control knob(s) to the HIGH position. **If you have more than two
burners, turn them on only ONE AT A TIME.
13. When all front burners are lit, close the grill lid.
14. Wait for 10‐15 minutes; the temperature should reach 400 – 450°F
WARNING
The cylinder valve always has to be in the horizontal position, to ensure that only the propane vapour is withdrawn.
Vapour
CORRECT WRONG WRONG WRONG
IMPORTANT
Always allow to completely cool off before covering your grill to prevent corrosion from condensation.
CAUTION
All cleaning and maintenance should be done when the grill is cool, with the fuel supply turned off at the control dial and the
propane cylinder disconnected. DO NOT clean any grill part in a self‐cleaning oven. The extreme heat will damage the finish.
Cleaning
Burning off the grill after every use (approx. 15 minutes) will keep excessive food residue from building up. Clean the grill before
and after cooking is recommended.
Recommended cleaning materials
Mild dishwashing liquid detergent Hot water
Nylon cleaning pad Wire brush
Paper clip Putty knife/scraper
Compressed air
DO NOT use cleaners that contain acid, mineral spirits or xylene.
Outside surfaces:
Use a mild dishwashing detergent and hot water solution to clean. Rinse thoroughly with water.
Inside surface:
If the inside surface of the grill lid has the appearance of peeling paint, baked on grease has turned to carbon and is flaking off.
Clean thoroughly with a strong solution of detergent and hot water. Rinse with water and allow it to completely dry.
Interior of grill bottom – Remove residue using brush, scraper and/or cleaning pad. Wash with a dishwashing detergent and
Cooking Grates – The porcelain grates have a glass‐like composition that should be handled with care. Use a mild dishwashing
detergent or baking soda and hot water solution. Non‐abrasive scouring powder can be used on stubborn
stains. Rinse with water.
Heat Plates – Clean residue with wire brush and wash with soapy water. Rinse with water.
Grease Cup – Periodically empty the grease cup and clean with a dishwashing detergent and hot water solution.
Cleaning the Burner Assembly
1. Turn gas off at the control knobs and propane tank.
2. Remove cooking grates and heat plate.
Vapour
Care and Maintenance
hot water solution. Rinse with water and let dry.
Vapour
- 15 -
Vapour