1-Sided/2-Sided Selection - Kyocera KM-2560 Advanced Operation Manual

1-sided/2-sided Selection

ADVANCED OPERATION GUIDE
Select the type and binding of original depending on the original.
The table below lists the binding directions for each original type.
Original
1-sided Sheet Original
2-sided Sheet Original
Open Book Original such
as magazine and book
* Only when the optional document processor is used.
NOTE:
To scan colored 2-sided originals using the optional document
processor, you need to add memory to the machine. Contact to your
service representative.
Use the procedure below to select the original type and binding direction
when sending scanned originals.
1
Place the originals on the platen.
2
Press the Send key.
3
Press [Type of Original/Transmission] and then [2-sided/Book Original]
4
Press [1-sided], [2-
sided], or [Book].
5
If you selected [2-sided] or [Book], you should also select the binding
direction and press [Original Orientation] to select the direction in which the
original is set on the platen.
6
Press [OK].
7
Specify the destination, and press the Start key to start sending.
Type
1-sided
2-sided*
Book
Ready to send.
Place original .
2-sided/Book Original
Binding
1-sided
2-sided
Press [OK] to display
Left
the image.
Book
Add Shortcut
Status
Sending Functions
2
Binding
—
Binding Left/Right,
Binding Top
Binding Left,
Binding Right
Destination
1
Right
Top Edge Top
Original
Orientation
Cancel OK
10/10/2007 10 :10
2-11