Changing Security Functions - Kyocera KM-2560 Advanced Operation Manual

Security

Changing Security Functions

Changing Security Password
Changing the Method for Erasing the Entire Hard Disk
8-6
Enter the security password to change security functions. You can
customize the security password so that only the administrator can use the
Security Kit.
Use the procedure below to change the security password.
1
Press the System Menu key.
2
Press [ ] and then [Security].
3
If user login is disabled, the user authentication screen appears. Enter your
login user name and password and then press [Login]. For this, you need
to log in with administrator privileges. The default login user name and
password are both
4
Enter the default security password, 000000.
5
Press [Change] of Security Password.
6
Press [Password] to
enter a new security
password 6 to 16
alphanumeric
characters.
CAUTION:
Avoid any easy-to-guess numbers for the security password
(e.g. 11111111 or 12345678).
7
Press [Confirm Password] to enter the same password again.
8
Press [OK].
Change the method for erasing the entire hard disk. Refer to Overwrite
Methods on page 8-2 for details.
NOTE:
The overwrite methods are used both for overwriting and system
initialization (page 8-8), and cannot therefore be set individually.
" "
3060 .
Security - Security Password
Set password.
Please enter new password, then re-enter it to confirm.
Password
Confirm
Password
Status
ADVANCED OPERATION GUIDE
Cancel OK
10/10/2007 10 :10