Table of Contents
Advertisement
Parameter
WAN Interface Settings
Dynamic IP
Static IP
PPTP Settings
PPTP Account
PPTP Password
Retype Password
PPTP Server
Connection ID
MTU
Maximum Idle Time
Connection Mode
To configure WAN Interface IP
The ISP requires you to obtain an IP address by DHCP before
connecting to the PPTP server.
Clone MAC Address
Select <Enabled> to allow replacing the WAN MAC address with
a specific MAC address.
MAC Address
Your ISP may require a particular MAC address in order for
you to connect to the Internet. This MAC address is the PC's
MAC address that your ISP had originally connected your
Internet connection to. Type in this MAC address in this section
Clone MAC Address"
or use the "
MAC address with the MAC address of that PC.
The ISP gives you a static IP to be used to connect to the
PPTP server. You must type in the related IP address such as
Address, Subnet Mask
Enter the PPTP Account provided by your ISP for the PPTP
connection.
Enter the Password provided by your ISP for the PPTP
connection.
Re-enter the Password for confirmation.
If your LAN has a PPTP gateway, then enter that PPTP
gateway IP address or domain name here. If you do not have a
PPTP gateway then enter the ISP's Gateway IP address above
or domain name.
This is the ID given by ISP. This is optional.
This is optional. You can specify the maximum size of your
transmission packet to the Internet. Leave it as it is if you do not
wish to set a maximum packet size. (The default settings is
1460)
You can specify an idle time threshold (seconds) for the WAN
port. This means if no packets have been sent (no one using the
Internet) during this specified period, the router will automatically
disconnect the connection with your ISP.
Select the desired option:
Keep-alive (maintain connection)
39
Description
button to replace the WAN
Gateway.
and
IP
Advertisement
Table of Contents
