Table of Contents
Advertisement
1.4 Getting Started
This is a step-by-step instruction on how to start using the router and get connected to the
Internet.
1) Setup your network as shown in the setup diagram below.
2) Then, you need to setup your LAN PC clients so that it can obtain an IP address
automatically. By default the XRT-401F's DHCP server is enabled so that you can obtain an IP
address automatically.
Please make sure that the XRT-401F's DHCP server is the only DHCP server available
on your LAN. If there is another DHCP on your network, then you'll need to switch one of
Note
the DHCP servers off.
Step1
Configure your PC to obtain an IP address automatically
This section will show you how to configure your PC's so that it can obtain an IP address
automatically for either Windows 98/Me, 2000 or later operating systems. For other
operating systems (Macintosh, Sun, etc.), please follow the manufacturer's instructions.
The following is a step-by-step illustration on how to configure your PC to obtain an IP address
a) Windows Vista, b)Windows XP, c) Windows 2000
automatically for
10
Advertisement
Table of Contents
