Hamamatsu Photonics C9300-201 Instruction Manual page 35

C9300-201 Ver.1.2
SVO
(Scan V-Offset)
Parameter
Function
SVW (Scan V-Width)
Parameter
Function
Example
SLP
(Scan Line Position)
Function
Example
ESC (External trigger SourCe)
Parameter
Function
(3) Correctional commands
CEG
(Contrast Enhance Gain)
Parameter
Function
Example
(4) Other setting commands
INI (INItialize)
Parameter
Function
RES
(RESponse)
Parameter
Function
Example
34H
n (0 ≦ n ≦ 472, n=multiples of 8)
Set the vertical start address for the sub-array readout. When the n
value is set to a number that is not a multiple of 8, the command
elicits an error (E3) in response.
m (8 ≦ m ≦ 480, m=multiples of 8)
Set the vertical line width for the sub-array readout. When the m
value is set to a number that is not a multiple of 8, the command
elicits an error (E3) in response.
Offset 64 (start address 64)
Width 256
SVO 64
SVW 256
SMD A
y1,y2,y3,y4,y5,y6,y7,y8,y9,y10,y11,y12,y13,y14,y15,y16
(0 ≦ y1...y16 ≦ 479, Parameters after y2 can be omitted.)
Sets the readout line for the line scan readout. The readout line
can be specified freely from 1 line to 16 lines.
M (Multi Timing I/O) /I (I/F)
Selects the input connector for external control pulse.
n (0 ≦ n ≦ 15)
Sets the gain for the contrast enhancement function.
Sets the gain to Low. (0 dB)
CEG 0
Sets the gain to High. (14 dB)
CEG 15
None
Initializes the contents of camera's internal parameter RAM.
Y (Yes) /N (No)
Determines whether or not responses are returned when
commands are executed.
Responses
RES Y
executed.
Responses are not returned when command are
RES N
executed.
AMAMATSU PHOTONICS K.K.
64
256
are returned when command are