Overview Of Commands - Hamamatsu Photonics C9300-201 Instruction Manual

C9300-201 Ver.1.2

10-4 OVERVIEW OF COMMANDS

The external control commands are categorized into the five following groups.
- Mode setting commands
- Parameter setting commands
- Correctional commands
- Other setting commands
- Status commands
(1) Mode setting commands
This group contains commands that switch the modes used in obtaining images.
AMD Selects the camera mode in the CCD exposure start timing.
Selects the method used to set the exposure time when the exposure timing is
NMD
controlled internally.
Selects the method used to set the exposure time when the exposure start
EMD
timing is External control mode.
SMD Selects the scan mode.
ADS Selects the digital data output bit count.
TNS
Selects the CCD output mode.
(2) Parameter setting commands
This group contains commands for setting parameters such as exposure time and
digital output pixel count.
SHT Sets the exposure time when the exposure trigger timing is controlled internally.
EST
Sets the exposure time when the exposure trigger timing is controlled externally
AET
Sets the exposure time.
ATP
Selects the external trigger pulse polarity.
Selects the binning count when the binning command is selected with SMD
SPX
command.
SVO Sets the sub-array's vertical start address.
SVW
Sets the sub-array's vertical line width.
SLP
Sets the line scan's readout line.
ESC
Selects the input connector for external control pulse.
(3) Correctional commands
This group contains commands for setting the contrast enhancement function and
other picture-correction settings.
CEG Sets the contrast enhancement gain.
(4) Other setting commands
This group contains commands for initializing the camera and for other setting.
Sets the various settings that determine the camera's overall operation to the
INI
initial values.
RES Selects whether responses are made to commands.
28H AMAMATSU PHOTONICS K.K.