Hamamatsu Photonics C9300-201 Instruction Manual page 10

CAUTION
•
Use low ripple noise power supplies since ripple noise may
affect camera performance.
The camera employs Hirose model HR10A-10R-12PB connector.
Number
1 GND (Camera)
2 12 V (Camera)
3
4
5
6
7
8
9
10
11
12
③ Camera mount
Jig for fixing the camera. Used when mounting the camera on a tripod or other fixture.
•
Be careful not to allow the fitting screw to enter more than 5
Note
mm from the surface of the mount. Screwing this in
excessively may impair normal operation.
④ CameraLink interface connector [DIGITAL OUT]
Connector used for connecting the camera to the CameraLink interface board.
⑤ Timing I/O connector [TIMING I/O]
The connector is used as the external trigger input (1
rd th
(3 pin, 4 pin).
•
Do not connect anything to 5
are reserved for options.
⑥ Mode switching switch
This switch is for the camera maintenance.
•
All positions are set to "OFF". Do not change this.
•
Power supply must satisfy the above specifications to prevent
trouble with the camera.
Signal Pin connection
NC
NC
NC
NC
NC
NC
NC
NC
NC
HR10A-10R-12PB
NC
th
HAMAMATSU PHOTONICS K.K.
st nd
pin, 2 pin) and the SG output
th
pin and 6 pin because they
C9300-201 Ver.1.2
9