Pitney Bowes OfficeRight DF800 Operator's Manual page 28

2 • Operation
8.. Unlock.the.separator.pad.
(lower.blue.lever),.and.align.
with.the.separator.roller.and.
relock.in.position..
Note:.When.using.Manual.Feed.
on.a.Crossfold.job,.the.Separator.
Roller.and.Pad.must.be.in.the.
central.position.and.the.Manual.
Feed.Lever.must.be.set.to.
Manual.
9.. Refit.the.Feed.Tray.
10.. Close.the.top.cover
11.. Set.the.Manual.Feed.Lever.back.to.Auto.
12.. Lift.the.weighted.roller.
13.. Load.material.with.the.
crease/.folded.edge.under.the.
weighted.roller.
NOTE:.The.Maximum.
number.of.sheets.in.the.tray.
in.Auto.mode.is.20.
14.. Lower.the.weighted.roller.
back.into.position,.over.the.
creased/.folded.edge.of.the.
material.
After.setting.up.the.machine.and.setting.the.stacker.follow.the.
Create.a.Job.setup.on.page.3-2.of.this.guide.and.select.the.crossfold.
option.when.asked.before.proceeding.with.your.crossfold.job..If.
your.crossfold.job.is.already.saved.as.a.job.continue.as.described.in.
Select.a.Job.on.page.2-2.
2-12
Weighted.Roller
SDC820A