Pitney Bowes OfficeRight DF800 Operator's Manual page 26

2 • Operation
Crossfold (optional extra on OfficeRight™ DF900)
The.crossfold.kit.is.sold.as.an.optional.extra.on.the.A3.folder.(DF900).
only..This.kit.allows.you.to.fold.material.that.has.already.been.folded.
by.the.machine.a.second.time.perpendicular.to.the.first.fold..This.kit.
is.engineer.installed.
Setting up a Crossfold Job
Initially.run.a.Single.Fold.folding.job.with.equal.length.panels.to.
provide.the.first.fold,.by.following.the.instructions.in.Create.a.Job.on.
page.3-2.of.this.guide.or.by.selecting.an.exisiting.single.fold.job.as.
described.in.Select.a.Job.on.page.2-2..
You.are.now.working.with.folded.material.and.need.to.setup.a.
crossfold.job.for.your.second.fold..Prior.to.this,.follow.the.instructions.
below.to.physically.set.the.folder.to.process.the.pre-folded.material..
Setting Machine for Crossfold Job
1.. Adjust.the.Side.Guides.to.
the.width.of.the.sheets.being.
fed,.using.the.Side.Guide.
Adjustment.Knob,.then.back-
off.a.1/4.of.a.turn..This.will.
set.the.correct.clearance.
between.the.guides.and.the.
material.
2.. Set.the.Manual/.Auto.feed.
lever.to.Manual.(to.the.right).
.
2-10 SDC820A