Setting.up.the.conveyor.stacker - Pitney Bowes OfficeRight DF800 Operator's Manual

2 • Operation
Setting up the Conveyor Stacker CS88
The.Conveyor.Stacker.is.the.
standard.stacker.unit.provided.
with.your.OfficeRight™.
Folder.DF900.Machine.and.is.
available.as.an.option.on.your.
OfficeRight™.Folder.DF800.
It.is.fitted.to.the.machine.with.
two.hooks.which.slide.into.the.
apertures.at.the.exit.of.the.
machine..
If.you.are.using.the.Conveyor.
Stacker,.it.will.need.to.be.set.up.
before.commencing.a.job.
During.job.setup.the.screen.will.
show.a.stacker.setup.number.
Lift.the.Stacker.Roller.and.place.
both.ends.in.the.corresponding.
number.slot.
Note:.Ensure.that.both.ends.are.
in.the.correct.number.slot.or.this.
could.result.in.material.skew.on.
exit.of.the.machine.
When.stacker.setup.is.complete,.continue.with.running.a.Trial.Piece.
as.described.on.the.next.page.
High Capacity Extension
The.High.Capacity.Extension.is.an.optional.extension.to.the.
Conveyor.Stacker..The.High.Capacity.Extension.will.allow.you.to.run.
a.large.volume.of.material.before.needing.to.empty.the.stacker..
Connect.the.High.Capacity.Extension.to.the.end.of.the.Conveyor.
Stacker.with.the.hooks.through.the.key.holes..You.can.then.secure.
the.Extension.to.the.Stacker.with.the.Thumb.Screw..
2-6 SDC820A