Feed.tray.setup.for.a.folding.job - Pitney Bowes OfficeRight DF800 Operator's Manual

Feed Tray setup for a Folding Job
This.section.describes.setting.up.and.loading.the.Feed.Tray.for.
automatic.feed.of.sheets..
If.you.select.a.Manual.Feed.job.(where.the.Feed.Tray.is.set.for.
manual.feed.of.sheets),.the.Feed.Tray.should.not.be.loaded.with.
material..This.is.because.the.sheets.are.manually.fed.one.set.at.a.
time..See.Manual.Feed.on.page.2-8.for.more.information..
To.process.a.Crossfold.job.(available.as.an.option.on.the.DF900.
only),.refer.to.the.Crossfold.Setup.procedure.on.page.2-10.
You.can.view.information.about.the.feed.requirements.for.your.job...
1....Press.the Loading Details and.then Load Tray Screen.Keys..
2.. Adjust.the.Side.Guides.to.
the.width.of.the.sheets.being.
fed,.using.the.Side.Guide.
Adjustment.Knob,.then.back-
off.a.1/4.of.a.turn..This.will.
set.the.correct.clearance.
between.the.guides.and.the.
material.
3.. Take.the.stack.of.sheets.
and.aerate.it.to.ensure.the.
individual.sheets.are.not.
stuck.together.
4.. Jog.the.stack.back.into.
alignment..
SDC820A
Operation • 2
2-3