Basic Operation; Switching On Receiver; Software Update - Mirage smartSTREAM - BOX2IP User Manual

 Replace batteries when the
range of the remote control is
decreasing or when the receiver
no longer reacts to all com-
mands.
 When not used for prolonged

periods of time, batteries may
leak. Remove batteries from the
remote control if it is not used
for long periods of time (> 1.5
years).
 When replacing batteries, al-
ways replace all batteries.
5

Basic Operation

This chapter describes the necessary steps to
use easily the radio and television programs
broadcasted via satellite.
5.1

Switching on Receiver

1. Switch on all connected devices.
2. Ensure that the correct AV input is selected
at the TV set (i.e. that the signals from the
receiver are displayed).
3. Connect the mains plug to the power outlet
to switch on the receiver
or
Switch on the receiver by using the power
switch (on the rear panel of housing) (I,
ON) 3 .
2F
5.2

Software Update

Once you have put your re-
ceiver

should first update the operat-
ing software of your receiver!
5.2.1 Update via USB
If you have Internet access, you should update
your receiver via the USB interface.
Depends on your receiver type.
3
into operation, you
1. Search for the upgrade file on the internet
page www.avanit.tv (menu item Support).
2. If the version number of the update file
matches with the version number of the
software of the receiver, which is displayed
in the submenu Information of the menu
Tools, you do not need to do anything
else. Your receiver is up to date. Otherwise
continue with step 3.
3. Save the update file to a USB data storage.
4. Unpack the file with the ending .abs.
Please note that the upgrade file
(*.abs) is copied directly to the root

directory of the USB data storage
(no subdirectory)!
5. Connect the data storage to your receiver.
6. In the menu Tools, select the sub-menu
Upgrade by USB and press the OK key.
7. At Upgrade Mode, select the upgrade
mode Allcode by using the keys
.
8. At Upgrade File, select the file copied in
step 2.
9. Select the Start button and confirm by
pressing OK.
A message saying that you will lose all per-
sonal settings will be displayed.
The upgrade will be performed after selecting
Yes
by using the keys
pressing OK. Then, the receiver will automati-
cally perform new start.
5.2.2 Software Update via Satellite
smart can also upload the update file on the
satellite Astra 19.2° E. You can then perform a
so-called OTA update:
4
3F
1. In the menu Tools, select the submenu
OTA Upgrade.
2. Leave all settings unchanged (factory
settings).
OTA = Over The Air = via Satellite
4
Basic Operation
und
und and
9