Operation In A Unicable System; About Unicable; Allocation Of If Channels And Frequencies; Installation - Mirage smartSTREAM - BOX2IP User Manual

10 Operation in a Unicable Sys-
tem
10.1

About Unicable

The HDTV receiver allows for changing the
receiving mode to the unicable standard. This
makes it possible to connect several inde-
pendent receivers (up to 12 - depending on the
used system) to only one main line.
For this, an own IF channel and a correspond-
ing frequency should be set for each receiver
via the settings menu.
Allocation of channels and frequencies de-
pends on the used LNBs and/or multi-
switches.
The data sheet and the technical documenta-
tion of your LNB and/or multi-switch include an
allocation table similar to the following table.
10.2 Allocation of IF channels and
frequencies
Receiver 1 1
Receiver 2 2
Receiver 3 3
Receiver 4 4
Receiver 5 5
Receiver 6 6
Receiver 7 7
Receiver 8 8
1284
1400
1516
1632
1748
1864
1980
2096

Operation in a Unicable System

 Enter the frequencies of your
receiving system into the last
column of the table so that all

relevant information is quickly
available. Rule of thumb:
highest frequency  shortest
cable path.
10.3

Installation

If the receiver is connected to a unicable sys-
tem, then RAPS installation will automatically
cancel. The window to the right will open.
1. Press the red function key (SHIFT) to
open the submenu Antenna Setup.
2. Select the menu item LNB Freq to set
Unicable(9750-10600)
3. Press the green function key to open the
window Antenna Setup Unicable Setting.
4. Select the menu item IF Channel and set
the IF channels (start with channel 1; re-
spectively allocate one of the IF channels -
in ascending order - to the connected re-
ceivers).
.
37