Lnb In / Out Loop Through (Loop Standby); Smartlink (Cec); Software Version; Factory Settings - Mirage smartSTREAM - BOX2IP User Manual

Extended Settings and Functions
9.11 LNB IN / OUT Loop Through (Loop
Standby)
(only with version II, see section "Re-
ceiver", page 4)
Basically, after turning off the receiver it
switches to power saving mode ("Deep
Standby", red LED lights up). At the LNB OUT
terminal there is no or only a highly attenuated
signal. If you want to use LNB OUT anyway,
you can set that in the submenu Other of the
System Setup menu:
 Select Loop Standby to switch on and off
the possibility of looping through the satel-
lite signal, using the buttons
(factory default is Loop Standby
off
).
If you select Loop Standby
On
, the receiver goes into
standby mode after switching
off, but not into the power sav-
ing mode. The display shows
CAUTION!
the current time.

9.12 SmartLink (CEC)

If you have a CEC
17
16F
receiver and TV set are connected via HDMI
you can switch on and off (standby mode) both
sets with the remote control of your receiver:
1. Select in the menu System the submenu
TV System and press OK.
2. Select SmartLink and use the keys
und to switch the SmartLink func-
tion on and off.
CEC = Consumer Electronics Control = HDMI
17
feature for entertainment units, provides via HDMI
various control functions, e. g. "one touch recording"
or "system standby". The TV set is the control center
and the TV remote control becomes the remote
control of the whole system.
36
und
-compatible TV set, and
9.13

Software Version

The submenu Information of the menu Tools
displays the current version number of the
receiver software.
9.14

Factory Settings

If you erroneously saved wrong settings or if
you want to pass on the receiver without your
settings, then you can reset the receiver to the
factory settings (reset):
To reset the receiver:
1. In the menu Tools, select the submenu
Factory Settings.
2. Press the OK key. You will be asked if you
want to reset the receiver and delete indi-
vidual settings.
3. Select Yes or No by using the keys
und , and then press OK. After reset-
ting your receiver, the language selection
menu will be displayed.