Mirage smartSTREAM - BOX2IP User Manual page 30

Extended Settings and Functions
3. Select Pos No. & Save to determine a
position number at which the respective
satellite (i.e. the respective antenna posi-
tion) should be saved.
4. Select Go to X to call a position from
which you want to make the selection (the
Reference
value is the zero position).
5. Select Save and turn the antenna to the
west or east by using the keys
. Search for maximum values of sig-
nal strength and signal quality (are dis-
played at the lower screen edge).
6. Then press OK to save the found position.
A query will be displayed.
7. Confirm change of position by pressing
Yes or discard such change by pressing
No.
8. Repeat the steps 1 to 6 for any further
satellites/transponders, if applicable.
 Select Recalculation and press OK to
discard any previous settings and to again
determine antenna position.
 Press EXIT to return to the submenu An-
tenna Setup.
Select Limit setup and press OK to open the
window Limit setup.
1. Select Limit setup to switch between
Disable Limit West Limit
,
2. Mark the button Limit setup and move the
limit - as defined in the previous step - to
the east or west by using the keys
and .
30
and
East Limit
and .
3. Mark the button Go to Reference and
then press OK to move the motor antenna
to its starting position.
4. Press EXIT to return to the submenu An-
tenna Setup.
9.1.3.2.2 USALS
A satellite position is defined as reference, and
the data provided for latitude and longitude are
then used together with such basic values to
calculate the rotary movement for all remaining
satellites.
 Select Local Longitude to enter the longi-
tude of the position of your antenna by us-
ing the numeric keys of your remote con-
trol.
 Select Local Latitude to enter the latitude
of the position of your antenna by using the
numeric keys of your remote control.
 Select Motor Setting and press OK to
open the submenu Motor Setting.
1. Select Satellite to select the satellite that
should be used as reference for USALS
control of the antenna.
2. Select Transponder to select the tran-
sponder that should be decisive for the an-
tenna position (usually the transponder that
is used to send your preferred channel).
3. Align your motor antenna so that signal
strength and signal quality (are displayed
at the lower screen edge) reach maximum
values.
4. Press EXIT to return to the submenu An-
tenna Setup.
 In the submenu Antenna Setup, select the
item Limit Setup and press OK to open
the window Limit Setup. Proceed as de-
scribed above.