Mirage smartSTREAM - BOX2IP User Manual page 29

You can set signal strength and signal quality
for receiving of a certain transponder:
 At Transponder, select the transponder
for which signal strength and signal quality
should be displayed at the lower window
edge by using the keys
(or select Transponder, press OK, select
the desired transponder from the list und
confirm by pressing OK).
No. Meaning
Sequential number of selected tran-
1
sponder
2 Total number of receivable transponders
3 Frequency (MHz)
4 Polarization, H = horizontal, V = vertical
5 Symbol rate (MS/s)
Orientation of your antenna is opti-

mal with maximum signal strength.
 When using a multi-feed antenna, select
the port for the respectively selected satel-
lite at DiSEqC 1.0
11
10F
 If you want to receive signals from more
than four satellites, select the port for the
respectively selected satellite at DiS-
EqC1.1
. This is set to
13
12F
 Select the menu item 22K to permanently
switch on or off the 22 kHz control voltage
for high-low band switching (this is re-
11 DiSEqC = Digital Satellite Equipment Control, a
digital control signal technology with satellite receiv-
ing systems
DiSEqC1.0 supports four satellite positions
12
DiSEqC1.1 supports 16 satellite positions
13
and
.
12
11F
Disable
by default.
Extended Settings and Functions
quired e.g. for certain antenna systems or
to avoid disturbances). In most cases,
is to be selected (factory setting).
 At Polarity, select the correct value for the
selected channel. Possible settings are
V
(horizontal), (vertical) and
setting is made to
9.1.3.2 Motor Antenna
 At LNB Freq, select the value correspond-
ing to the used LNB. Default value is a uni-
versal LNB with 9750 - 10600 MHz.
 At Motor Type, select the used control
signal technology. Select between
1.2 USALS
and
14
13F
motor). The submenu item Motor Setting
states different settings depending on your
previous selection.
9.1.3.2.1 DiSEqC 1.2
 Select Delete All to delete all previously
set satellite positions.
 Select Motor Setting and press OK to
open the submenu Motor Setting:
To set various antenna positions:
1. Select Satellite to select the satellite to
which the following settings should apply.
2. Select Transponder to select the tran-
sponder that should be decisive for the an-
tenna position (usually the transponder that
is used to send your preferred channel).
As compared to 1.0 and 1.1, DiSEqC1.2 offers the
14
additional possibility of rotor control, USALS = Uni-
versal Satellites Automatic Location System (particu-
larly simple motor antenna control)
Auto
. Factory
Auto
.
DiSEqC
(depending on the used
Auto
H
29