Extended Settings And Functions; Installation - Mirage smartSTREAM - BOX2IP User Manual

Newer Windows systems are DLNA
compatible by default, and therefore

DMR compatible (regarding play-
back on a media renderer...).
3. Navigate to the menu Media, navigate to
Small2Big and press OK.
On the TV screen "Small2Big standby" ap-
pears. The receiver waits to receive an AV
stream.
4. Start the app which can connect to the
DMR and check in the app settings,
whether the receiver is selected as render-
er.
If there occur questions regarding
the operation or troubleshooting of

the apps which are used for BOX2IP
and Small2Big, contact the appro-
priate app's supplier support.
5. In the app, select the files which should be
played via the receiver's renderer and the
TV set. Possible formats: JPG, BMP, MP3,
MPEG2, MPEG4 (AVC/ H.264)
The receiver indicates, that it receives data
and plays it on your TV screen.
9 Extended Settings and Func-
tions
9.1

Installation

The default settings apply to a standard satel-
lite system. Any further system functions (e.g.
unicable system or motor antenna) should be
manually set in the menu Installation:

CAUTION!
In case of doubt, have
those settings being
made by an expert. Usu-
ally, there are no required
settings within scope of
normal use of the system.

Extended Settings and Functions

9.1.1 Antenna Connection
1. In the menu Installation, select the sub-
menu Antenna Connection and confirm
by pressing OK.
2. Select by using the keys
Fixed Antenna
if a
connected to the receiver.
3. Press EXIT to leave the submenu Antenna
Connection.
4. Press EXIT again to leave the menu Instal-
lation and to return to TV operation, or go
to another submenu
If you selected a
then such antenna should be further

configured at the menu item Anten-
na Setup.
9.1.2 Satellite List
The submenu Satellite List states a preset list
of possible satellites. Depending on your an-
tenna system you can select the satellites used
for receiving channels:
1. In the menu Installation, select the sub-
menu Satellite List and confirm by press-
ing OK
2. Select the satellite you want to receive by
pressing the keys PR+ and PR-, and con-
firm by pressing OK.
The selected satellite will be correspond-
ingly marked ( ).
You may also edit the satellite
list by selecting one of the but-

tons on the right edge of the
menu window.
To change an entry:
1. Press the red function key (SHIFT).
2. Select by pressing the keys PR+ and PR- if
you want to change name or longitude (po-
sition).
and
Motor Antenna
or a is
Motor Antenna
,
27