1 .
Holding on to the bulb with tissue or paper towel, gently pull bulb down out of
socket (1) .
2 .
After bulb is loose from socket, lift it out of the machine (2) .
3 . To replace the bulb, follow the procedure, Installing the Curing Bulb
on page 14 .
CLEANING THE UNIT
The internal parts of the build and curing chamber can be wiped clean with 70% isopropyl alcohol and a soft, non-scratching cloth,
(such as a microfiber). Make certain you inspect the glass that is a part of the print cartridge support. Remove the glass and clean any
resin, fingerprints or any other debris which may have accumulated.
Glass
Print Cartridge
Support
3D Systems, Inc.
Cleaning Cartridge Holder
38
1
2