Table of Contents
Advertisement
D) Slide one end loop of the Inner Wide Fabric Shroud (72) and the Inner Narrow Fabric
Shroud (71) onto an Upper Shroud Bracket (62) so the seams face towards
weights, the Narrow Fabric Shroud is to the front, and the flat section of the
Upper Shroud Bracket is towards the back of the Machine. Attach the Upper
Shroud Bracket (62) to the Front Upper Shroud Mount Bracket (59) and lower hole
of the Right Upper Shroud Mount Bracket (61) using 2- M6x12 Button Head bolts (95)
and 2- M6 washers (101), one on each side as shown. Leave these bolts loose for
adjustment later.
E) Slide the Lower Shroud Bracket (64) through the loop of the lower ends of the Inner
Wide Fabric Shroud (72) and the Inner Narrow Fabric Shroud (71) so the flange on
the Lower Shroud Bracket (64) is towards the back of the machine. Make sure the
seams are on the inside. Slide the front end of the Lower Shroud Bracket (64) into
the insert on the Right Base (1). The other end latches under the notched flange and
attaches with 1- M5x10 Phillips Head Screw (96) and 1- M5 washer (102). Tighten
this screw now.
F) Make sure the outer edges of each shroud are straight. Go to the top of the Shrouds
and push up on each side of the Upper Shroud Bracket (62) and tighten the bolts
(95) in the bracket while holding the Upper Shroud Bracket up tight to take any slack
out of the shrouds. Bolts (95) should be tight now, and the shrouds should be
taught.
G) Tighten the bolts in step 14 on the Right Upper Shroud Mount Bracket (61)
to the Right Top Beam (15) Now.
H) Repeat A-G in this step for the left side of the machine.
I) Attach the front of the Outer Right Metal Shroud (69) to the Front Upright (4R) using
2- M6x12 Button Head bolts (95) and 2- M6 washers (101). Attach the rear of the
Outer Right Metal Shroud (69) to the Right Upper Shroud Mount Bracket (61) using
1- M6x12 Button Head bolt (95) and 1- M6 washer (101). Tighten these bolts
now.
J) Attach the front of the Inner Right Metal Shroud (68) to the Front Upright (4R) using
2- M6x12 Button Head bolts (95) and 2- M6 washers (101). Attach the rear of the
Inner Right Metal Shroud (68) to the Right Upper Shroud Mount Bracket (61) using 1-
M6x12 Button Head bolt (95) and 1- M6 washer (101). The downward arc in the
Inner Metal Shroud should line up with the opening between the Narrow and Wide
Inner Shrouds. Tighten these bolts now.
K) Repeat I-J in this step for the left side of the machine.
PAGE 22
Hide quick links:
Advertisement
Table of Contents
