Table of Contents
Advertisement
Pulley 19
43
42
40
77
Note: Make sure all cables
are run between the
retainer pin and the pulley.
A) Route the Rear Cable (34) starting with the small swage end without the ball stop. Slide
cable under and up behind Pulley 17 from front to back, then over floating Pulley 18 (Make
sure the tab on the floating pulley bracket is sticking towards the back of the
machine) and down around Pulley 19 as shown.
B) Next slide the Cable Ball (43) over the swage of the cable end at Pulley 19 and insert the
swage into the "U" Bracket Cable End (42). Now place a Spring Clip (77) between the "U"
Bracket Cable End (42) and insert the Button Head Bolt (40) through the "U" Bracket and
Spring Clip into the Flat Head Nut (41) as shown. Tighten now.
C) Attach a Spring Clip (77) to the other end of this cable also.
D) Repeat this step on the other side of the machine.
E) The cable assembly tightness can be adjusted at the lower cables threaded cable
ends on the in the bases from step 11. Make sure to tighten the jam nut after
adjusting.
STEP 12
41
Rear Cable #
695-500-003
PAGE 18
Rear Cable
Pulley 17
Pulley 18
Hide quick links:
Advertisement
Table of Contents
