Inspire FT2 Assembly & Operation Manual page 12

74
29
74
85
29
10
76
107
107
A) Insert the Linear Bearing Shafts (10) into the collars at the bottom of the Front Uprights (4R & 4L).
Attach these with 4-M6x5 Set screws (107) at the bottom of the collars to hold the Linear Bearing
Shafts (10) in place. Tighten the Set screws now. Slide one (larger ID) Slider Rubber Donut
(76) down each of the Linear Bearing Shafts (10).
B) Attach a Red Slider Adjustment Handle (55) to the shafts on the side of each of the Right and Left
Sliders (8 & 9) with a M5x8 Socket Head Cap Screw (44) in the head of each handle.
C) Note: The Right and Left Sliders (8 & 9) are placed on the Front Uprights (4R&L) and Linear
Bearing Shafts (10) at the same time with the Red handles facing towards the inside of the gym.
This Red handle must be held in the upward position to allow it to be placed on the Front Upright
(4R&L).
Next slide the Right Slider (8) down the Linear Bearing Shaft (10) and Right Front Upright (4R) on
the right hand side of the gym to about the number 20 position on the Upright (4R).
step on the left side of the gym using the Left Slider (9) on the Linear Bearing Shaft (10) and the
Left Front Upright (4L).
D) On both Uprights attach the Slider Pulley Swivels (29) to the Sliders (8 & 9) using 2-M12x85 Hex
bolts (85), 4-M12 washers (74) and 2-M12 Lock nuts (93).
Tighten this hardware now but ensure that the swivel moves freely.
STEP 4
93
8
55 44
44
55
93
74
85
4R
10
76
107
107
PAGE 9
Swivel Pulley Sliders
74
9
2-larger ID Slider Rubber Donuts (76)
4L
76
2 - M12*85 Hex Bolts (85)
4 – M12 Flat Washers (74)
2 – M12 Locknuts (93)
107
107
4 - M6x5 Set screws (107)
Repeat this