Inspire FT2 Assembly & Operation Manual page 24

70
Step 15, Weight Shrouds
A) Slide one end loop of the Outer Fabric Shroud (70) onto an Upper Shroud Bracket
(62) so the seams face towards weights and the flat section of the Upper
Shroud Bracket is towards the back of the machine. Attach the Upper Shroud
Bracket (62) to the Front Upper Shroud Mount Bracket (59) and lower hole on the
Right Upper Shroud Mount Bracket (61) using 2- M6x12 Button Head bolts (95) and
2- M6 washers (101), one on each side as shown. Leave these bolts loose for
adjustment later.
B) Slide the Lower Shroud Bracket (64) through the loop of the lower end of the Outer
Fabric Shroud (70) so the flange on the Lower Shroud Bracket (64) is towards the
back of the machine. Make sure the seams are on the inside. Slide the front end of
the Lower Shroud Bracket (64) into the insert on the Right Base (1). The other end
latches under the notched flange and attaches with 1- M5x10 Phillips Head Screw
(96) and 1- M5 washer (102). Tighten this screw now.
C) Make sure the outsides of the shroud are straight. Go to the top of the Shroud and
push up on each side of the Upper Shroud Bracket (62) and tighten the bolts (95) in
the bracket while holding the Upper Shroud Bracket up tight to take any slack out of
the shroud. Bolts (95) should be tight now, and the shroud should be taught.
STEP 15
69
62
64
1
61
62
59
4R
71
PAGE 21
Flat section towards
back of machine.
68
10 - M6*12 Button Head Bolts (95)
10 - M6 Flat washers (101)
72
4 - M5*10 Philips Head Screws (96)
4 - M5 Flat Washers (102)
64