Lan Settings - Furuno Felcom 250 Operator's Manual

6. WEB FUNCTIONS
6.1.8

LAN settings

The LAN Settings must be performed by the network manager.
How to set the LAN IP address
Click [Settings] in the menu bar, the [Network settings], [LAN] and [IP address] in the
sub-menu. The following screen appears.
Item
Own IP address
IP address
Subnet mask
Alive monitoring
Enabled/Disabled
IP address
DHCP server
Lease information
button
DHCP
From
To
Apply button
Cancel button
6-10
Enter the LAN IP Address (IPv4 Address). Default: [192.168.1.1.]
Select the LAN Subnet mask.
Check [ ] Enabled if WAN communication is available. (Default:
Disabled)
When enabled, the terminal sent an ICMP request can respond.
(This will indicate if the internet is available.)
Enter the IPv4 address of the server according to the ICMP re-
quest. (Default: 192.168.1.2)
Go to the DCHP lease information screen.
Use: Use DHCP Server in the communication unit.
Unuse: Do not use DHCP Server.
Enter assigned commencement IP address (IPv4 address). Fac-
tory setting is [192.168.1.10].
Enter assigned last IP address (IPv4 address). Factory setting is
[192.168.1.254].
Click to apply settings. The screen shows "The CmmUnt will re-
start automatically after this settings. Continue?" → [OK] button →
"Completed. Please wait a moment for restarting." displays →
press the [OK] button to close message → Equipment restarts.
Restore previous settings.
Description