Furuno Felcom 250 Operator's Manual page 74

3. SETTINGS FOR HANDSET
2. Press 3 to select [Clock] and show the [Clock settings] screen.
3. Select [NTP server] then press the Enter key.
4. Press
address input screen.
5. Select [IP address] then press the Enter key to show the IP address entry screen.
6. Enter the IP address (maximum 15 characters) of the communication unit then
press the Enter key.
7. Press the
8. Press the
Note: The time displayed on the handset can be adjusted to show local time. Use the
following procedure to enable UTC time offset.
1. In the [Settings] menu, press 1 to open the [Basic] menu.
2. Press 3 to select [Clock] and show the [Clock settings] screen.
3. Select [Time zone] then press the Enter key.
4. Press
5. Press the
Note: The UTC offset settings are only applied to individual handsets. To apply the
setting to other handsets, repeat the procedure for each handset.
3-12
to select Manual then press the Enter key to show the NTP server IP
key to apply the setting.
key to close the menu.
or to adjust the UTC offset as required then press the Enter key.
key to close the menu.
Displayed handset
time changes with
UTC adjustments