Host Serial Response Time-out
Parameter # 9Bh
This parameter specifies how long the decoder waits for an ACK or NAK before resending. Also, if the decoder wants to send, and
the host has already been granted permission to send, the decoder waits for the designated time-out before declaring an error.
To set the delay period (options are 2, 5, 7.5, or 9,9 seconds), scan one of the following bar codes.
Other values are available via SSI command.
Note
*
Low - 2 Seconds
High - 7.5 Seconds
(14h)
(4Bh)
SSI Interface 6-11
Medium - 5 Seconds
(32h)
Maximum - 9.9 Seconds
(63h)